|
|
|
|
Operation:
- Paper tube is fed onto the cutting mandrel from right to left of the operator's station. The tube is then fed toward the cutting wheel by a pre-selected digital motor control that feeds the tube to the desired lengths.
- The downward motion of the knife handle automatically starts the tube rotating while being cut and stops the rotation when the arm is raised. When in the raised position, a signal is sent telling the automatic feed to advance the tube to the next pre-selected cut.
- The previous cut tube will be pushed off the cutting mandrel as the next tube advances. If a longer tube length is required, a roller bed table is used for either a manual removal or, if desired, drop onto a parallel catch tray stand.
- 3/4" I.D. - 30" O.D. tube diameters
- 27" - 74" tube lengths
- 1" maximum wall thickness
- 2 3/8" minimum cut length
- 10 knivesd maximum
- No tooling required
<< Previous |
|
|
|